The synchronous belts Replacement

This forum is for general dicussion about the site. Feature requests, problem, concerns, whatever. Sound off.

The synchronous belts Replacement

Postby allenlu » Mon Jun 21, 2021 12:32 am

These belts are also referred to as high-torque, positive-drive, or timing belts. The belts are toothed and require the installation of matching toothed-drive sprockets. They are mainly used in industrial settings because they offer high efficiency of up to 98%.

When compared to V-belts that record a sharp efficiency reduction within a short time because of slippage, synchronous belts guarantee high efficiency over a longer period.

Experienced Manufacturer & Supplier in China. Guaranteed Top Quality & Service. Quality Raw Edge Cogged Belts Supplier & Manufacture in China, Contact Now!

The synchronous belts require less maintenance and retensioning. They also work effectively even in oily and wet environments without slipping.

The main disadvantage of using synchronous belts is that they are noisy. They also transfer vibrations and are less suitable for shock loads.

If you need to change the V-belts, the decision to go with cogged or synchronous depends on your preference. If you do not want to make modifications on your system, go for the cogged model. However, it is the synchronous system that guarantees the highest efficiency in the system in your facility.

www.rubberbeltmanufacturer.com
allenlu
Frontiersman
 
Posts: 11
Joined: Wed May 27, 2020 12:04 am

Return to General Site Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron